NETGEAR Router Login – routerlogin.net

NETGEAR Router Login – routerlogin.net: All routers come with a pre-built configuration host that is known as the router admin panel. It is the management page that requires an admin login and that can be used for various settings specific to the modems/routers. In case you are facing any issue related to the way your network works, you can always connect to this page and fix it. However, there is one big prerequisite for this, which is – you should be connected to the network.

How to login NETGEAR Router?

So, in order to access or login to routerlogin.net, your computer, laptop or phone should be connected to the network (wired/wireless). In case you are unable to connect to routerlogin.net, check your internet connection and try again.

Things that you can do once you have logged into the settings:

Change your WiFi password and SSID (WiFi name) with ease.
Change your router’s login password and username (highly recommended).
Enable or disable dual-band connections, i.e. 2.4Ghz and 5Ghz WiFi connections.
Block devices from accessing your network (using their MAC address).
Block certain websites from being accessed on your network.
Set wireless network scheduling.
Update the firmware.
Unlock max bandwidth.
Enable guest mode (like on airports and malls).

About Nighthawk App

In case you are not sure how to go about the settings panel or are too afraid to configure the router yourself, then the Nighthawk app is for you. There are a lot of perks to using this app.

It can be used to do a number of things like performing necessary speed and latency checks and updating the firmware.
Checking internet speeds will become easy once you have the Nighthawk app installed. It routes the connections to your network so that you get optimal speeds all the time.
Latency checker is again one of the popular features. A high latency connection is prone to drops and is also unstable. So, using Nighthawk app’s ping tester is a good way to test your latency.
You can always access routerlogin.net or routerlogin.com by visiting the Cannot access router login page. You will find the necessary information related to logging in to your admin panel over here.
As mentioned earlier, you need to enter the correct IP address that is mapped to your router in order to access the admin page. This is the default gateway IP and it can be fetched by using ipconfig inside the command prompt.
Open your web browser and then type either of the following IP addresses: 192.168.1.1 or 192.168.0.1. It should load up the admin panel for you.
Login to the admin panel using your router credentials (usually they are admin and admin).

Changing the WiFi password using Routerlogin.net admin panel

In order to save all the other devices that are connected to a wireless network, it is advised that you use a strong WiFi password. Routerlogin.net or the router’s admin panel ensures that your WiFi is always secured with a good password. In order to set (or update) the WiFi password, this is what you have to do:

Firstly, you need to open a web browser – like Chrome, Safari, or Firefox.
After that you need to enter the default IP/gateway address – 192.168.1.1.
Log in when you are prompted to (admin/admin config or custom username and password).
Once you are logged in go to the option that says Wireless or WLAN.
Go to Management > Pre-shared key (will be shown only when your security type is set to WPA/WPA2 instead of Open).
Set the password of your choice (you can also change the SSID from over here).
Click on Apply and Update.
The router will reboot and your settings will get applied once it has rebooted.

Troubleshoot Guide:

In case the Routerlogin.net page has been cached by your web browser, you will have to try the steps after clearing the cache memory. In order to clear cache, do the following steps: