Dlinkap.local is router used for your internet services. To have fair access to your Dlinkap.local router, you’re required to use the admin panel of the same.
Here, we are sharing a guide where you will know how to get into the interface of your Dlinakp.local router and make the configurations.
How to log in to Dlinkap.local Router?
To log in to the admin panel, you’re required to follow the given steps which are as below-
- Ensure that you open a web browser which could be Chrome, Firefox or any of your choice.
- Now in the given address bar, type 192.168.0.50 and press enter. It is the default IP address for Dlinkap.local routers.
- You are now landed to the home page where you can use your username and password to log in.
- Enter admin as your username. The default password for the same is blank.
- Once you enter both, press enter and you can see the admin panel of your router.
How to change SSID of Dlinkap.local Router?
For changing the SSID of your router which is also advisable, follow the given steps-
- Open a web browser of your choice. Make sure you’re using an updated version of your browser.
- Now type 192.168.0.50 in the address bar. If it doesn’t work for you, type dlinkap.local and press enter.
- Now the login prompt will appear on your screen.
- Use your default username and password in the required fields and hit enter.
- Now you can see the admin panel of your router.
- From the home page, go to the management dashboard page.
- Management Dashboard>Management.
- From there, tap on admin.
- You can see the SSID field. Enter your new username and hit save.
How to change the password of Dlinkap.local Router?
For changing the password of your Dlinkap.local, follow the given instructions-
- Tap on your preferred browser and open it.
- Use the address dlinkap.local or 192.168.0.50 into the address bar.
- Hit Enter.
- You can now see the home page.
- Go to management dashboard>Management.
- Hover to Admin button.
- Below the SSID field, you can see the password column.
- Enter a new password.
- Save the changes.
How to Factory Reset your Dlinkap.local router?
If you’re using a D-link range extender and you want to reset it to its factory default settings, then here are the given steps that you can perform in order to reset your router.
- First, you need to locate the reset button available on your extender. You can find it on the back or bottom of your device.
- Use a paperclip or a sharp needle and hold the reset button for like 15 seconds. The moment you release your button, the power LED will blink and will get stable in few seconds only.
- Make sure that you do not turn on or off your device in this process. It may take a few seconds but you need not touch it in between.
- Now you have to unplug the extender for about 10 seconds and then plug it back and wait for another 30 seconds.
- It is now done. Your extender is now reset to its factory default settings. You can now set up your router again.
